My desk top is 30 inches from the floor and it is 32" deep so the converter's 31.5" depth was perfect for my use case and it didn't overhang the front or back of my desk, allowing for tidy wire management, and comfortable typing. I could raise or lower the desk converter to the proper height with one hand, as advertised.
Switching from sitting to standing at this desk was easy with the weight of my monitors, keyboard, mouse and (large) cup of coffee. The outside edge of each monitor did overhang the Flexispot M2B converter, but my desk backs up to a wall, so that was no issue for me. The center of each monitor base was about 6" in from the outside edge on either side, and the two monitors were angled in slightly. I was able to place both monitors on the M2B 35" converter without using a hydraulic mounting arm or anything beyond the stands that my monitors came with. I have a comfortable ergonomic chair, and take frequent breaks to get up and move around my home, walk my dog, etc. How Does it Hold Up to Everyday Use Image Courtesy FlexiSpotĪs I mentioned earlier, I work from home and spend around 50 hours a week at my desk. I'm 6'2" and on my desk top the keyboard tray was at the perfect ergonomic position when standing (My forearms were at a slightly open position, at about 100 degrees). It's easy to lock the desk in to a number of different heights (there are 12 individual height adjustments, one more than is available with the VARIDESK converter). This speaks to the quality of the hydraulic struts. Lowering the desk converter takes a bit more downward force (this is ultimately aided by the weight of your monitors), but is not difficult. It can be raised easily with one hand via a lever just below the desktop on the right-hand side. I probably would have boxed it up and not placed it on my desk if this hadn't been the case, so I feel it's worth pointing out to folks with nicer desks who are considering adding a standing desk converter that won't damage their desk. In my home office I have a 7 foot long red oak desk with breadboard ends that I built in my workshop a few years ago, and I was pleased to see that the Flexispot comes with nice padded feet to prevent any damage.
0 kommentar(er)
